Tips & Instructions > Single Dip Fluid Bed Instruction Sheet

• Use only clean dry air.
• Turn on air supply to fluid bed before adding powder.
• Keep air pump away from powder dust so the filter on air pump doesn't become clogged and restrict air flow.
• Plug in vibrating motor and add powder.
• Regulate air to bring powder to a slight boil.
• Too much air flow will result in excessive dust.
• Dip preheated part into fluidized powder and remove at once.
• If powder smokes, the part is to hot.
• Powder should finish melting within several seconds after the part is removed from powder.
• To change powder color, empty excess power into a container for future use. Vacuum out cup and add new color.
• Do not run vibrating motor without air flowing through the fluid bed.
• Turn vibrating motor off when not dipping to avoid overheating.
• Certain colors will fluidize better without the vibrating motor on. Try each color with and without vibrating motor for best results.